There are a handful of little laundry-room problems that are easy to ignore until they start to feel messy, and a lint roller flopping around on a shelf is one of them. This quick project turns an ordinary wooden lint roller into a tidy, upright brush station by slipping it into a small ceramic flower pot and dressing the pot with wrapped twine so it feels intentional instead of improvised.
I love projects like this because they solve a real household annoyance in about the time it takes to brew tea, and they still look polished when you’re done. If you want a simple, useful DIY that adds a bit of warmth to a laundry room, mudroom, or closet shelf, this is exactly the kind of low-effort, high-payoff detail I’d make in an afternoon.
Materials
Instructions
1. Wipe the outside of the ceramic pot clean with rubbing alcohol or soapy water, then dry it fully so the glue and twine will grip well.
2. Cut your felt to fit the bottom inside the pot, then glue it in place to cushion the wooden handle and keep the roller from clicking against the ceramic.
3. Add a small line of hot glue near the bottom edge of the pot and press the end of the jute twine into it, holding for a few seconds until secure.
4. Wrap the twine around the pot in tight, even rows, adding a dab of hot glue every 1 to 2 inches and especially at the back so the front stays neat.
5. Continue wrapping all the way to just below the rim, keeping each row snug against the last so you get full coverage without gaps.
6. Cut the twine, tuck the end at the back of the pot, and glue it down neatly; if you like, add one extra band around the rim area for a finished, basket-style look.
7. Check the inside of the pot for any stray glue strings, remove them, and set the pot upright on a flat surface to make sure it sits evenly.
8. Slide the wooden lint roller handle down into the pot so the sticky roller sits above the rim and the handle rests on the felt-lined bottom.
9. Test it by lifting the roller out and dropping it back in a few times; if it wobbles too much, add another small felt piece inside the bottom or a little weight, like a few pebbles under the felt, to steady it.
10. Place the finished station beside folded towels, detergent jars, or your ironing supplies so the lint roller is always easy to grab when you need a quick pass over dark clothes.
Variations & Tips
Add weight: If your pot is very lightweight, glue a few smooth pebbles or a small bag of aquarium gravel into the bottom before adding the felt so the station feels sturdier.
Change the wrap: Natural jute gives a warm, utility-room look, but cotton rope or black-and-white baker’s twine will shift the style if your laundry room is more modern or farmhouse.
Leave a ceramic border: For a cleaner, more tailored finish, stop the twine 1/2 inch below the rim so a slim band of white ceramic still shows at the top.
Make it kinder to surfaces: Add three or four tiny felt pads under the pot if you plan to keep it on a painted shelf, washer top, or delicate countertop.
Coordinate the room: I like to repeat materials in small ways, so if you already have wicker baskets or wood hangers in the laundry room, this twine-wrapped pot will look especially at home.
Refill-ready setup: Keep one extra lint roll refill tucked in a nearby drawer or basket; this station works best when the roller is always loaded and ready instead of becoming another half-finished chore.