If your laundry room always seems to collect the same little clutter like a lint brush, stray dryer sheets, and mystery socks, this is the kind of tiny project that makes the whole space feel more put together. I love a DIY that takes about as long as a coffee break, and this magnetic lint brush station is one of those satisfyingly practical upgrades that looks neat, works hard, and uses almost no room.
I designed this version around a small cork trivet mounted right on the side of the dryer with a strong magnet hidden behind it, so there’s no drilling, no sticky residue on the appliance, and no bulky organizer getting in the way. If you’re busy like I am and just want the lint brush to live in one obvious spot instead of wandering all over the laundry room, this is absolutely for you.
Materials
Instructions
1. Wipe the back of the cork trivet and the side of the dryer with rubbing alcohol, then let both dry completely so the magnet and station sit clean and flat.
2. Find the center of the back of the hexagonal cork trivet with a ruler and mark it lightly in pencil so the magnet will sit balanced.
3. Spread a generous, even layer of epoxy on one face of the round neodymium magnet, then press it firmly onto the center mark on the back of the trivet for 30 seconds.
4. Set the trivet face down and let the adhesive cure fully according to the package directions; if needed, place a small flat object on top to keep the magnet tightly seated while it dries.
5. Test the hold by placing the trivet on the side of the dryer at a comfortable grab height, usually 8 to 12 inches below the top edge and toward the front corner.
6. Mark the spot with two small pieces of painter’s tape, remove the trivet, and check that the dryer surface is smooth and the door still opens freely without bumping the brush.
7. Put the trivet back in place with the magnet against the dryer, then press firmly so it sits flush and doesn’t wobble.
8. Hang or lean the lint brush against the cork station so the brush head rests on the cork and the handle stays easy to grab; adjust the trivet height if needed for the most secure resting position.
9. Load-test the station by removing and replacing the brush several times, then shift the trivet slightly higher or lower until it feels natural to use one-handed.
10. If you want a more finished look, trim away any visible cured glue squeeze-out and lightly dab the cork edges with a clean cloth so the station looks polished and intentional.
Variations & Tips
Use a larger trivet: If your lint brush has a wide head or heavier handle, use an 8-inch cork trivet and a 2.5-inch magnet for a little more contact area and a sturdier landing spot.
Seal the cork: A thin coat of clear matte sealer helps the cork resist dust and laundry-room humidity without changing the simple natural look.
Pick the right magnet strength: I like a strong neodymium magnet here because dryer walls are thin metal, and a weak craft magnet usually slides too easily once you start grabbing the brush every day.
Make it match your laundry room: You can leave the cork natural, or paint just the outer edge in white, black, or a soft sage green for a more custom look while keeping the front mostly cork.
Add a second station: If you have room, make another magnetic trivet for dryer sheets or a small stain-remover brush so the whole side of the dryer works harder without feeling cluttered.
Keep it renter-friendly: Since the magnet does the holding, this setup is easy to remove and reposition later, which is one of my favorite things about it when I’m trying to organize without committing to a permanent install.