In a small hallway, the tiniest everyday fixes can make the biggest difference. This simple flashlight station uses a small wall-mounted metal funnel as a holder, so your flashlight has an easy, obvious home instead of getting lost in a junk drawer right when the power goes out. I love projects like this because they take about as long as unloading the dishwasher, but they make the house feel so much more functional.
I’m especially fond of this one for busy households, narrow entryways, mudrooms, and those awkward little stretches of wall that are too tight for a shelf. When life is moving fast, having a grab-and-go flashlight parked in the exact same spot every time is genuinely helpful. I’ve done versions of this in utility spaces before, and this hallway version looks neat, polished, and intentionally organized instead of improvised.
Materials
1 small brushed metal funnel, about 4 to 5 inches wide across the top opening
Instructions
1. Choose a hallway wall spot that is easy to reach but out of the main traffic path, ideally 48 to 54 inches from the floor to the center of the funnel.
2. Hold the funnel against the wall with the narrow end pointing downward and test-fit the flashlight inside to make sure it sits securely and can be grabbed quickly with one hand.
3. Clean the wall where the funnel will mount using rubbing alcohol on a cotton pad, then wipe the back contact points of the funnel the same way and let both surfaces dry fully.
4. Mark the top edge and center point lightly with pencil so you can place the funnel straight on the first try.
5. Apply the adhesive mounting strips to the outside back edges of the funnel, spacing them evenly around the upper half where the metal will touch the wall most firmly.
6. Press the funnel onto the wall using your pencil marks as a guide, keeping the wide opening facing up and the narrow spout pointing down, then apply firm pressure all around for 30 to 60 seconds.
7. Let the adhesive set according to the package directions before adding weight; for the strongest hold, wait the full recommended cure time.
8. Wipe the flashlight and the visible metal funnel with a microfiber cloth so the station looks clean and finished.
9. Slide the flashlight into the funnel with the handle down and the grip end easy to grab, adjusting the angle if needed so it rests snugly without tipping forward.
10. Test the station a few times by removing and replacing the flashlight with one hand, then erase any visible pencil marks and straighten the flashlight for a polished final look.
Variations & Tips
Add a second station: If your hallway serves as both entry and exit space, mount a second funnel lower down for a backup flashlight or emergency grab-and-go item.
Choose the right funnel size: The flashlight should slide in easily but not disappear deep into the funnel; a top opening around 4 to 5 inches wide usually gives a secure, accessible fit.
Use matching finishes: A brushed metal funnel looks especially nice near stainless hardware, satin nickel hooks, or modern entryway décor, and it helps the project look intentional instead of temporary.
Mind the wall surface: Adhesive strips work best on smooth, clean painted walls, metal, tile, or finished wood; I would skip this method on brick, rough plaster, or heavily textured walls.
Keep it emergency-ready: Check the batteries every few months or use a rechargeable flashlight and make recharging part of your seasonal home reset routine.
Make it family-friendly: If kids need to reach it too, mount the funnel a little lower in a side hallway or mudroom wall section where they can safely grab the flashlight without stretching.